Safety; General; General Information Regarding Safety And Warning Instructions - Kerbl C 10 Mode D'emploi

2. Safety

2.1 General

• Read the following instructions carefully before assembling and using the unit.
• Anyone tasked on behalf of the user with commissioning, operation, maintenance or repair must have read and understood the operating in-
structions and in particular the chapter on safety.
• The company using the unit is recommended to draw up in-house instructions taking account of the respective operator's known technical
qualifications and to have the compliance with the instructions and operating instructions or participation in a training session confirmed in
writing.
• The unit must only be operated, maintained and repaired by trained and authorised personnel.
• The responsibilities for the various activities that arise during the course of the operation and repair or maintenance of the unit must be clearly
defined and complied with, so that no unclear competencies arise from the aspect of safety. With all work relating to commissioning, mainte-
nance, inspection or repair, the regulations or advice listed in the operating instructions must be observed.
• Failure to comply with the individually listed points in the operating instructions can result in physical injury or material damage for which the
manufacturer assumes no liability.

2.2 General information regarding safety and warning instructions

Danger!
Imminent danger which leads to serious physical injury or death.
• For any kind of maintenance and cleaning work, the entire C10 circulation pump must be disconnected from the mains voltage and secured
against being switched on again.
• Work on and adjustments to the control unit, pump, heating element and electrical cables may only be carried out by a qualified electrician.
• In the event of malfunctions, disconnect the unit from the mains voltage. The fault must be eliminated only by authorised personnel.
• The C10 circulation pump must be operated with a separate residual current circuit breaker. Connect the connecting cables of the unit to a
mains disconnection device in accordance with the regulations.
• The residual current circuit breaker should only supply the circuits intended for this unit
• Check the function of the residual current circuit breaker regularly using the function key.
Caution!
Risk of physical injury to people and animals and material damage if used incorrectly!
• Before commissioning and operating the unit, these operating instructions must be read and noted carefully.
• Ensure that the unit is only used by people who have the professional skills required to do so.
• Keep children and frail individuals away from the unit.
• Note the safety and maintenance instructions.
• Maintenance and cleaning work must only be carried out by trained personnel.
• The operator must ensure that only authorised personnel work with or on the unit.
• The circulation pump must never be operated without water. Doing so will cause irreparable damage to the pump as well as the heating ele-
ment.
• Risk of frost damage to the unit as well as to ring pipes and drinking bowls due to improper use.
• Hot water may escape during ventilation. Hot surfaces are not always obvious.
• Additives in the supply water can cause damage to the entire circulation pump, as can aggressive cleaning agents.
• Fire hazard. The unit must be mounted on a fireproof base.
• Do not run electrical cables over the hot flow pipe or water pipes. Electrical cables can be damaged.
• The unit must be used exclusively in accordance with intended use and in a technically safe condition!
The operational safety of the unit is only guaranteed if it is used for its intended purpose. Failure to comply with the individually listed points in
the operating instructions can result in physical injury or material damage for which the manufacturer assumes no liability.
• Any manner of working that impairs safety on the unit is prohibited.
• Keep all safety and danger notices on/at the unit complete and always in a legible condition.
• The operator is obliged to check safety-relevant parts before commissioning and, in the event of any defects, resolve these defects before com-
missioning.
• If the mains cable to this unit is damaged, it must be replaced by the manufacturer or authorised specialist authorised to avoid danger.
• As a matter of principle, no guards may be dismantled or put out of operation.
• If a guard needs to be removed for repair, the guard must be refitted once the repair work has been completed.
• Operation of the unit is only permitted with components and spare parts that are supplied or listed in the spare and wear parts list.
• The maintenance intervals specified in these operating instructions must be observed.
• Only use genuine spare parts.
34