Makita BBC300L Manuel D'instruction page 11

cord on it.
80mm
2
010992
Hook the center of new nylon cord into the notch in the
center of the spool, with one end of the cord extending
about 80 mm (3-1/8") more than the other.
Then wind both ends firmly around the spool in the
direction of the head rotation (left-hand direction
indicated by LH and right-hand direction by RH on the
side of the spool).
1
010993
Wind all but about 100 mm (3-15/16") of the cords,
leaving the ends temporarily hooked through a notch on
the side of the spool.
1
010994
1. Spool
2. For left hand
rotation
1
1. Notches
100mm
1. Eyelets
Mount the spool in the housing so that the grooves and
protrusions on the spool match up with those in the
housing. Keep the side with letters on the spool visible
on the top. Now, unhook the ends of the cord from their
temporary position and feed the cords through the
eyelets to come out of the housing.
3
010776
Align the protrusion on the underside of the cover with
the slots of the eyelets. Then push cover firmly onto the
housing to secure it. Make sure the latches fully spread
in the cover.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
TROUBLE SHOOTING
Before asking for repairs, first, conduct your own
inspection. If you find a problem that is not explained in
the manual, do not rashly dismantle the equipment.
Instead, ask Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
11
1. Cover
1
2. Protrusion (Not
shown)
3. Slot of the
2
eyelet