Proline CDEP70-E Notice D'utilisation page 40

40
3.
Delicate
Cotton
Cotton Cycle: to be used for cotton.
Synthetics
Synthetics Cycle: to be used for synthetic
or delicate items.
Delicate
Pressing this button allows drying to be
performed at a lower temperature, for deli-
cate items. The corresponding pilot light
comes on. This option can also be used for
time controlled drying.
Starting the programme
Start/Pause button to start the
Press
dryer after having selected the programme
and the options. The relevant light will stop
flashing. If the programme selector dial is
turned to another position, when the ma-
chine is running, the buzzer will sound and
the programme phase indicator lights will
flash. The drum turns alternately in both di-
rections during drying.
All drying programmes end with a 10 mi-
nute cooling phase. You may remove the
laundry after this phase.
If the door of the appliance or the small
door at the bottom is opened while the pro-
gramme is running, this button must be
pressed again after closing the door in or-
der to restart the programme from the point
at which it was interrupted. This button
must be depressed also after a power fail-
ure and after having reinserted the water
reservoir, if it has been emptied in the mid-
dle of a programme after lighting up of light
Water reservoir.
In both cases the light of the
Pause button flashes to remind you that the
start button needs to be pressed again.
Indicator lights
These lights indicate the following functions:
•
Drying light: This light indicates that
the appliance is in the drying phase.
•
End of programme light: This
light is on at the end of the cooling
phase, during the anticreasing phase and
at the end of the programme.
•
Water reservoir light: This light indi-
cates that the appliance is in the drying
phase. This light comes on at the end of
the programme to remind you that the
water reservoir must be emptied out. If
this light illuminates during a programme
this means that the water reservoir is full.
The buzzer sounds, the programme
stops, the light of the
ton flashes. This light comes on also
when the water reservoir is not inserted
correctly.
•
end of the programme to remind you that
the filters must be cleaned.
•
cycles to remind you that the condenser
must be cleaned.
Changing programme
To change a programme which is running,
first cancel it by turning the programme se-
lector dial to
gramme and press the
ton.
At the end of the programme
If the laundry is not removed at the end of
the cycle, the dryer performs an anticreas-
ing phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer
will stop automatically at the end of the an-
ticreasing phase. Lights
programme,
voir remain lit and the buzzer sounds for 2
minutes.
Turn the programme selector dial to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
If you do not intend to carry out another
wash, close the water tap. Leave the door
Start/
open to prevent the formation of mildew
and unpleasant smells.
After each use
• Clean the filters.
• Empty the water reservoir.
Filter light: This light illuminates at the
Condenser light: It comes on every 80
. Select the new pro-
Filter and
If you open and then close the door
before turning the selector dial to
the lights corresponding to the phases
making up the performed programme
come on.
Start/Pause but-
Start/Pause but-
End of
Water reser-
to
all