Numatic CDC 371 Mode D'emploi page 12

This machine can be used for wet and dry pick up.
If the vacuum cleaner stops working switch off and remove the plug from the wall before
investigating were the fault lies.
If the vacuum cleaner will not pick up any debris from the surface, switch off and remove the plug from the wall,
inspect the floor tool, wands and hose for blockages, if no blockages are found, the dust bag may be full if the
dust bag is not full the filter may be blocked.
If the vacuum cleaner stops working switch off and remove the plug from the wall before investigating were the
fault lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch off and remove the plug from the wall,
has the float valve operated, this will shut off the suction and the pitch of the vacuum motor will change Remove
the power head and empty the liquid out of the container, if the container is empty, check that the floor tool
wands and hose are not blocked.
After use always inspect the machine for damage.
CDC 371
CDC 371
Failure to rectify the problem or in the event of a breakdown contact your
Numatic dealer or the Numatic Technical helpline +44 (0)1460 269268
Motor AirFlo
1200W 40 L/sec
Capacity Capacity
Dry Wet
15 Ltrs 9 Ltrs
Fault Finding / Dry Mode
Fault Finding / Wet Mode
Suction Cleaning
Range
2500 mm 28.8m
Size Weight
355x355x510 7.1 Kgs
Data
Class
II
Sound
Pressure
73-77 dB
(IEC 60704-2-1)
Uncertianty: 0.2 dB (A)