SystemRoMedic Helena Manuel D'utilisation page 6

6
Assemble in the following order:
- End stop
- Traverse rail carrier
- End stop
To prevent the traverse rail carrier from gliding along the rail during
assembly of the second support leg, anchor it to the support leg that
has already been assembled. We recommend anchoring the traverse
rail carrier with the help of an end stop (image 4). When assembly is
complete, slide the end stop to the other end of the rail and leave it in
place.
Mount the second primary rail on the other support leg.
Insert the end-stop screws into the pre-drilled holes (image 3).
Fit the screw covers.
4
Mount the crossbeams to the first pair of support legs:
Tighten bolts with a 17mm open-end wrench. Mount screw
covers on bolt heads (image 5).
5
Attach the second pair of support legs to the first cross-
beam (image 6).
Then, mount the other crossbeam between the pairs of
support legs.
6
I F U