SystemRoMedic Helena Manuel D'utilisation page 5

Assembly of lift stand
(11)
Place the corner pieces on the top ends of the legs as illustrated. Mount through bolts (11) and locking nuts. Tighten
with two 17mm open-end wrenches (not included). Mount screw covers on bolt heads.
Mount legs pair-wise, so that the carrier handles are on the outside. (Image 1)
Affix the mounting fixtures loosely to the top sides of the corner pieces using bolts (9), (10) and washers (13). Mount the
first primary rail by inserting it into the mounting fixture on the corner piece. Before inserting the rail all the way in, press a
rail cover (8) into the end of the rail. Tighten bolts with a 17mm open-end wrench. (Image 2)
M10x25
M10x25
M10x16
M10x16
I F U
(10)
(8)
NOTE! Make sure the longer bolt (10) is
inserted into the primary rail's safety hole! (Image 3)
3
1
(9)
(14)
2
5