Charging The Power Pack - Hama LED10S Mode D'emploi

G Operating instruction
Controls and displays
1. On/Off switch
2. 2x USB-A connection
3. Micro-USB connection
4. LED capacity indicator
5. USB-C connection
6. Micro-USB charging cable
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these
instructions in a safe place for future reference. If you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of warning symbols and notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to speci c hazards
and risks.
Note
This symbol is used to indicate additional information or important notes.
2. Package contents
• Power pack with LED capacity indicator, 10000 mAh
• Micro-USB charging cable
• These operating instructions
3. Safety instructions
• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating and use it in dry environments only.
• As with all electrical products, this device should be kept out of the reach of children.
• Do not drop the product and do not expose it to any major shocks.
• Do not operate the product outside the power limits speci ed in the technical data.
• Do not open the device or continue to operate it if it becomes damaged.
• Dispose of packaging material immediately in accordance with the locally applicable regulations.
• The battery is permanently installed and cannot be removed; dispose of the product as a whole in
accordance with the statutory regulations.
• Do not modify the product in any way. Doing so voids the warranty.
4. Operation

4.1. Charging the power pack

• Start the power pack charging process by connecting the enclosed Micro-USB charging cable to
the Micro-USB input on the power pack (IN 5V/2A) and to a suitable USB charger. Alternatively,
you can also charge the power pack via the USB-C input (IN 5V/2A). To do this, consult the
operating instructions for the USB charger you are using.
• The charging process begins and ends automatically.
• Fully charge the power pack once before using it for the rst time.
2