Quick Start - Digital Works ReZAP Battery Doctor Guide D'utilisation Et D'entretien

QUICK START

STEP 1: TURNING THE CHARGER ON
• Extend the power cable stored in the base compartment.
• Plug the charger into a proper indoor electrical outlet and turn on the
power, the red LED lights up indicating the charger is active and ready
for use.
STEP 2: CONNECTING THE BATTERIES TO THE CHARGER
• Ensure that batteries are in good condition before charging them. DO
NOT attempt to charge any battery that has sign of rust, chemical
leakage or deposit on the terminals. These should be disposed of
immediately to avoid subsequent damage to charger and/or electronic
appliances.
o Although battery leakage found on some faulty/damaged/old batteries
will typically not cause immediate damage to unprotected skin, it is
best to avoid contact, or if contact occurs, immediately wash the
exposed area with soap and running water.
• Place used batteries to be charged into the charger slots according to
their different sizes as follows and ensure all batteries are connected
correctly to the charger. Pay attention to battery polarities.
o AAAA, AAA, AA, C, D, N and prismatic size (1.2V or 1.5V) batteries
can be inserted into any of the four main slots.
o 9V battery should only be plugged into the 9V terminals provided (the
far left slot).
o 6V dolphin/lantern battery should be connected to the charger via the
pair of cable clips provided, which can be extended out from the base
storage compartment. Please ensure that the RED clip is connected to
the POSITIVE (+) terminal of the battery and the BLACK clip is
connected to the NEGATIVE (-) terminal of the battery. If wrongly
connected, our built-in reverse protection circuitry will activate and the
charge current will be cut out. (GREEN light not flashing).
6