Operating Display Indicators - Weka Holzbau SC 10-T Instructions De Montage Et Mode D'emploi

Anleitung SC 10_T mehrsprachig
GB

Operating display indicators

LED color
Red
Red
Green
Green
No indication
Note:
For safety reasons, the controller switches off the heater after an operating period of 6 hours. Resetting is
only possible with the operating switch.
Setting the sauna temperature
When the main switch (No. 1) is actuated, the heater
heats up the sauna to the temperature set with the
regulator knob (No. 3).
Exception: This does not happen when the electronic
fine atomizer is inside the sauna. In this case the
temperature is heated to a maximum of 60°. For an
exact description please see the installation and
operating instructions of the evaporator unit.
12
11.07.2003 06:50 Uhr
Indicator lights up
X
X
Setting the time (timer function)
The time remaining before the heater is switched on
can be set with button + (No. 6) and button - (No. 4).
Signals are issued by a total of 12 LEDs (each LED
represents exactly one hour). The selected time can
be changed at any time by pressing the buttons „+"
or „-". If you keep on pressing the button - until the
display is at 0 again, the heater will switch on
immediately.
The timer function can also be used to arrange a
break in operation. To do so, keep pressing the
button + until the required break period (time
remaining until the heater switches on again) is
selected. Heating starts up again when the set period
has elapsed.
Seite 12
Indicator flashes Function
The heater is
heating up
X The fine atomizer
(if available) is inside
the sauna and the
HC 10-D controller
is not switched on
X Broken sensor
The heater is not
heating because the
temperature has been
reached; time is
pre-selected
6 hours
Safety cut-out