Setting The Unit Of Measure / Default Settings - terrapin X Guide Utilisateur

SETTING THE UNIT of MEASURE / DEfAULT SETTINGS

The unit of measure is the only setting which can be set directly. It can be displayed
either in meter or yard. Other settings can be configured in combination with the
corresponding app (see page 28).
By changing the unit of measure as described below, all other configurations will be
reset to factory settings.
Press and release the push button to turn on the device.
X
The electronic aiming mark appears.
Click the push button 6 times in rapid sequence.
X
The currently set unit of measure is displayed together with
four blinking digits.
Click the push button to change the unit of measure.
X
Conduct again 6 clicks on the push button in rapid se-
X
quence to store the displayed unit of measure and reset
all other configuration to factory setting.
Four, one after another displayed"–" symbols indicate a
successful completion.
The factory settings are:
à Range Gate: Disabled
à Declination: 0.0
6×
27