terrapin X Guide Utilisateur page 23

As long as the button is pressed, the device carries out continuous range measure-
ments. Approximately every 0.5 seconds a new measurement is conducted and its
value shown.
After releasing the push button, the last measured range will be displayed.
X
While the display is on, keep on clicking to display the equivalent horizontal
X
range, the elevation angle and the azimuth (see also "Complete measurement" on
page 21).
Keep on clicking to display the range and the other values.
X
à The scan mode is in particular useful for measuring the range to small
or moving objects.
à Because of the continuous measurements, power consumption is
greater in scan mode than for single measurements.
à Depending on the configuration, the measurement data will be trans-
mitted via Bluetooth to a receiving device (e.g. Smartphone or Kestrel
Weather Meter).
à A fast flashing Bluetooth symbol is indicating a Bluetooth connection
error.
23