After Treatment - Eurotops AP-3WD Mode D'emploi

Removal of Calluses
1. Remove the protective cap (1) from the device.
2. Switch on the device by simultaneously pressing the re-
3. Place the rotating roller (9) against the callus which is to be
4. Switch off the device after use by simultaneously pressing

After Treatment

1. After treatment, apply cream to the feet so that the skin
2. Clean the device after each use (see the "Cleaning and
01306_DE-EN-FR-NL_A6_V1.indb 27 01306_DE-EN-FR-NL_A6_V1.indb 27
• For dry application, make sure that there are no
cream or care oil residues on your feet.
• The device may be used under the shower and in
the bathtub. CAUTION! The device may become
wet, but must not be fully immersed under
water!
lease button (7) on the On / Off switch (4) and sliding the
On / Off switch (4) upwards (I will now be visible beneath
the On / Off switch (4)).
removed and move the device back and forth and to the
sides on the callus. Move the device slowly and without
pressure.
If the device is pressed too fi rmly against the skin, the
roller (9) will stop automatically to prevent skin injuries.
the release button (7) of the On / Off switch (4) and slid-
ing the On / Off switch (4) downwards (0 will now be visible
above the On / Off switch (4)).
becomes soft and tender.
Storage" chapter).
27 EN
02.11.2017 10:39:06 02.11.2017 10:39:06