Firmware Updating; Updating The Firmware With Usb Memory Devices; Initializing The Unit; Restoring It To The Factory Preset Settings - Yamaha XDA-QS5400RK Mode D'emploi

FIRMWARE UPDATING

Updating the firmware with USB memory devices

You can update the firmware using USB memory devices.
Download the firmware update file from the Yamaha website to a
PC, and copy it to 4 USB memory devices in advance.
Note
• Each ZONE needs the firmware update.
• Use 4 USB memory devices to update the firmware of the 4
Zones at once.
1
Turn each ZONE to standby and disconnect the
power cord from the AC wall outlet.

INITIALIZING THE UNIT

Restoring it to the factory preset settings

To initialize the unit, select "Factory Preset" from the "Web setup"
screen, or set all Zones to standby and then hold down the
CONNECT1 and CONNECT2 keys simultaneously for 5 seconds
or longer. When it becomes initialized, the power of ZONE1 will
also turn on.
2
Connect the USB memory devices to the USB jacks
of ZONE1 to ZONE4 on the front panel.
3
While holding down CONNECT1 and CONNECT3 on
the front panel, plug the power cord into the AC wall
outlet.
The firmware update starts. The STATUS indicator of each
ZONE flashes during the update and the MAIN STATUS
indicator lights up in sky blue.
4
When the update is finished, press STANDBY1 to
reset all of the ZONEs.
When updating is finished, the STATUS indicator on each
ZONE is turned off and the MAIN STATUS indicator lights up
in white.
EN
En 15