Tetra Tetronic LED Connect Complete Set 580 Mode D'emploi page 11

Installation options
The adapters provided enable the LED luminaire to be attached
in the following ways:
• Placing the LED luminaire on the edge of the aquarium
Both multi-adapters included in the set are required for this
option.
Prerequisite: Aquarium edge thickness = 4-10 mm
Procedure: → Fig. B
• Placing the LED luminaire in the T5/T8 bracket for
fluorescent tubes
For this option you will need:
– both T5 or T8 adapters supplied with the set.
– both original union nuts with seals for the T5 or T8
brackets.
Procedure: → Fig. C
• Screwing the LED luminaire to the aquarium lid
For this option you will need:
– both multi-adapters supplied with the set.
– 6 suitable screws. Please note that special fastening
materials may be required depending on the condition
of the installation site. Please enquire about this in a
specialist store.
Procedure: → Fig. D
• Installing the LED luminaire on Tetronic LED arms
The Tetronic arms bracket is available as an accessory for
aquariums or terrariums without a lid.
Procedure: → Fig. E or F
Connecting the LED luminaire
Procedure: → Fig. G
Please note:
• The LED luminaire connector must be positioned correctly to
ensure it fits onto sockets P1 and P2.
• The union nut on the LED luminaire connector must
always be screwed on by hand to ensure safe contact
and compliance with the protection rating specified in the
technical data.
UK
11