Télécharger Imprimer la page

Ergotron Neo-Flex Mobile Media Center Manuel De L'utilisateur

Ld 90˚ portrait/landscape rotation
Masquer les pouces Voir aussi pour Neo-Flex Mobile Media Center:

Publicité

Liens rapides

Holds displays with the following
VESA mounting hole pattern:
• 100 x 100 mm
• 200 x 200 mm
• 200 x 300 mm
• 300 x 200 mm
• 300 x 300 mm
• 400 x 200 mm
• 400 x 300 mm
• 500 x 200 mm
• 500 x 300 mm
• 600 x 200 mm
• 600 x 300 mm
• 200 x 400 mm
• 300 x 400 mm
• 400 x 400 mm
• 500 x 400 mm
• 600 x 400 mm
Holds displays with the following
VESA mounting hole pattern:
• 75 x 75 mm
• 100 x 100 mm
• 200 x 100 mm
• 200 x 200 mm
15mm
888-24-073-M-02 rev. M • 01/13
25 - 50 lbs
(11.3 - 22.7 kg)
25 - 36 lbs
(11.3 - 16 kg)
Stored Energy Hazard: The lift mechanism in the tower is under tension and will move up rapidly, on its own,
as soon as attached equipment is removed. For this reason, DO NOT remove equipment or make adjustments
to lift tension unless the front assembly has been moved to the highest position on the tower! Failure to
Riesgo de energía almacenada: El mecanismo de elevación de la torre está bajo tensión y se moverá
rápidamente hacia arriba por sí solo si se retira el equipamiento que hay conectado al mismo. Es por ello
que NO deberá quitar equipamiento ni hacer ajustes en la tensión de elevación a menos que la estructura
delantera se haya movido antes hacia la posición más alta de la torre. No seguir estas instrucciones podría
<30 lbs
Danger : Le mécanisme d'élévation dans la tour est sous tension et se lève rapidement, tout seul, dès que
(15 kg)
le matériel est retiré. Pour cette raison, NE PAS retirer votre matériel ou faire des ajustemensts à la tension
d'élévation à moins que la partie avant n'ait été mise à la position la plus élevée de la tour ! Risque de blessure
<5 lbs
(2.2 kg)
13mm
14mm
Neo-Flex Mobile Media Center, LD
with 90˚ Portrait/Landscape rotation
20"
(510 mm)
20"
(510 mm)
follow this instruction may result in serious personal injury and/or equipment damage!
ADVERTENCIA
provocar daños personales y/o materiales graves.
AVERTISSEMENT
corporelle ou d'endommagement matériel en cas de non respect de cette instruction.
Manuel de l'utilisateur
-15˚
+5˚
-25˚
+5˚
WARNING
User's Guide
Guía del usuario
1 of 16

Publicité

loading

Sommaire des Matières pour Ergotron Neo-Flex Mobile Media Center

  • Page 1 Neo-Flex Mobile Media Center, LD with 90˚ Portrait/Landscape rotation User's Guide Guía del usuario Manuel de l’utilisateur -15˚ Holds displays with the following VESA mounting hole pattern: • 100 x 100 mm • 200 x 200 mm • 200 x 300 mm +5˚...
  • Page 2 Leg Mounting Hardware M10 x 60mm Leg Cover Mounting Screws M3.5 x 6mm Shelf Mounting Hardware M3 x 37mm TM Mounting Hardware M6x8mm M8 x 14mm M4 x 16mm 400mm Extension Hardware M5 x 16mm Large Display Cart Hardware 5.1(ID) x 10(OD) x 6mm M6x20mm 8.1(ID) x 16(OD) x 6mm M4x20mm...
  • Page 3 Shipping Box Caja de embalaje Boîte d'expédition 15mm Leg Mounting Hardware Leg Cover Mounting Screws M3.5 x 6mm CAUTION: DO NOT overtighten fasteners. Overtightening may cause damage to your equipment. Cuidado:: No sobreapriete los tornilllos, pues podría causar un daño al equipo. Attention: ne forcez pas le serrage de la vis, cela pourrait endommager l’écran et/ou les attaches.
  • Page 4 Shelf Mounting Hardware M3 x 37mm Shelf Mounting Hardware M3 x 37mm 888-24-073-M-02 rev. M • 01/13 4 of 16...
  • Page 5 25 - 36 lbs 25 - 50 lbs (11.3 - 16 kg) (11.3 - 22.7 kg) Continue to Step 4 on page 8... Continúe por el paso 4 en la página 8... Suite à l'Étape 4 en page 8… 8 of 16 M5 x 8mm M6 x 8mm 888-24-073-M-02 rev.
  • Page 6 25 - 36 lbs (11.3 - 16 kg) 75x75mm 200x100mm 200x200mm 100x100mm M4 x 6mm M4 x 6mm M4 x 12mm M4 x 6mm M6 x 14mm M6 x 14mm 888-24-073-M-02 rev. M • 01/13 6 of 16...
  • Page 7 It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these 25 - 36 lbs adjustment steps to ensure safe and optimum operation.
  • Page 8 25 - 50 lbs (11.3 - 22.7 kg) TM Mounting Hardware TM Mounting Hardware M8 x 14mm 13mm M6x8mm Continue to Step 6 on page 9... 100 mm Continúe por el paso 6 en la página 9... 100 mm Suite à l'Étape 6 en page 9… 9 of 16 200 mm 300 mm...
  • Page 9: Important

    FIND APPROPRIATE FASTENERS FOR YOUR DISPLAY: BUSQUE ABRAZADERAS APROPIADAS PARA LA PANTALLA: 25 - 50 lbs TROUVEZ LES FIXATIONS APPROPRIÉES À VOTRE ÉCRAN : (11.3 - 22.7 kg) Large Display Cart Hardware 5.1(ID) x 10(OD) x 6mm M4x20mm 8.1(ID) x 16(OD) x 6mm M6x20mm M4x40mm 5.1(ID) x 10(OD) x 18mm...
  • Page 10 100x100mm VESA Plate Hardware 25 - 50 lbs (11.3 - 22.7 kg) M5 x 10mm 100 mm 100 mm Use fastener chosen from Step 6. Utilice la abrazadera elegida en el paso 6. Utilisez la fi xation choisie au cours de l’étape 6. 200 mm 300 mm 400 mm...
  • Page 11 25 - 50 lbs (11.3 - 22.7 kg) TM Mounting Hardware M4 x 16mm TM Mounting Hardware 888-24-073-M-02 rev. M • 01/13 11 of 16...
  • Page 12 25 - 50 lbs (11.3 - 22.7 kg) It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation.
  • Page 13 Power Strip Hardware M5x9mm Cable Management Support Hardware Cable Management Support Hardware M5x8mm 888-24-073-M-02 rev. M • 01/13 13 of 16...
  • Page 14 Cable Management Support Hardware NOTE: Leave enough slack in cables to allow full range of motion. No deje el cable excesivamente tenso Laisser du mou dans le câble Top Cap Hardware M5x8mm 888-24-073-M-02 rev. M • 01/13 14 of 16...
  • Page 15 3.69” (93.7 mm) 3.2” (80 mm) 38.4"-58.4" (974 - 1484 mm) 38.4"-58.4" (974 - 1484 mm) 64" (1633 mm) 64" (1633 mm) 9.8" (249 mm) 9.8" (249 mm) 5" 16.8" (127 mm) 5" (427 mm) 9.8" (127 mm) (250 mm) 16.8"...
  • Page 16 DO NOT push Cart from front or back possible hazards. Only of Tower. DO NOT move Cart over cords or Ergotron-approved installers may uneven, dirty, soft or sloping surfaces. DO service or otherwise modify NOT move Cart by pushing on Display. Failure cart/stand.