Troubleshooting - Meister MAS36VL Traduction Du Manuel D'utilisation Original

5450020-Akku-Schra_man 23.02.18 14:12 Seite 70
• Setting the direction of rotation
The cordless screwdriver can be used to screw screws in or out. In order to
set the direction of rotation, proceed as follows:
1. Screwing screws into place:
Push the switch for right/left operation (6) to the right side of the
screwdriver handle (3) in the housing.
2. Position the screw bit centred on the screw head.
3. Carefully push the On/Off switch with integrated light switch (5).
The screw bit and bit holder rotate to the right; the screw rotates in the
wood.
4. Screwing screws out:
Push the switch for right/left operation to the left side of the screwdriver
handle in the housing.
5. Position the screw bit centred on the screw head.
6. Carefully push the On/Off switch with integrated light switch.
The screw bit and bit holder rotate to the left, the screw rotates out of the
wood.
9 – Troubleshooting
Many problems can be caused by minor errors, which you can rectify
yourself. Follow the instructions contained in the following table.
If the fault on the cordless screwdriver cannot be rectified please contact
Customer Services.
Do not repair the cordless screwdriver yourself.
Problem
The cordless
screwdriver does
not start.
70
Possible cause
The battery power
is too weak.
The right/left rotation
is set to the centre
position.
Remedy
Charge the battery
(see chapter
"Charging the
battery")
Push right or left
fully.