Initial Start-Up; Use; Switching The Appliance On; Inserting Paper - UNITED OFFICE UAV 250 A2 Mode D'emploi

Initial start-up

NOTE
► As every shredder is tested for functionality after manufacture, it is possible
that you may find paper residue in the cutting blades .
■ Push the small waste container 2 onto the rails inside the large waste
container 4 .
■ Place the cutter attachment 1 onto the large waste container 4 so that the
mains cable sticks out to the rear .
■ Insert the plug into a mains socket .

Use

You can shred up to 10 sheets (80 g/m
max.
10
x 80g/m
CAUTION! PROPERTY DAMAGE!
Never feed paper into the cutter opening if it still has paper clips larger
than 25 mm attached! These could damage the cutting blades .

Switching the appliance on

■ Set the switch 9 to "AUTO" for shredding . The "Power" lamp 7 lights up
permanently green .

Inserting paper

■ Insert paper into the cutter opening for paper 6 from above and in portrait
format .
The motor starts automatically and switches itself off automatically if no further
paper is inserted . You can shred up to 10 sheets (80 g/m
time .
NOTE
► Regularly remove any residue left in the cutting blades with a suitable tool,
e .g . a pair of tweezers . Ensure that the appliance is unplugged before
doing this .
■ 18
GB │ IE
│
2
paper) at the same time .
2
paper) at the same
UAV 250 A2