Hart VP205-C-3701 Manuel D'utilisation page 11

MAINTENANCE
EMPTYING THE COLLECTION TANK
See Figures 30-33.
WARNING:
Always disconnect the plug from the power outlet
before removing the power head from collection tank.
• Verify that the power cord is disconnected from
the outlet.
• Disconnect the hose from the vacuum.
• Undo the latches and remove the power head
from the collection tank. Place power head on
a soft, clean surface upside down.
• Clear all dirt or debris from the collection tank
and hose into a proper waste container.
• Clean or replace the filters.
• Check the hose, attachments, and power cord
to ensure that they have not been damaged.
• Place the power head back onto the collection
tank and secure latches.
IMPORTANT! Clean or change the filter
regularly for best performance. ALWAYS USE
THE REUSABLE CLOTH FILTER FOR DRY
VACUUMING. If the machine is used without the
reusable cloth filter, the motor will burn out and
the warranty will be voided. Always keep spare
filters on hand.
NOTICE! The filters included are made of high-
quality materials designed to stop small dust
particles. The reusable cloth filter should be used
for dry pick-up only. A dry reusable cloth filter is
necessary to pick up dust. If the reusable cloth
filter is wet, it will clog quickly and be very difficult
to clean. Handle the filter carefully when removing
it for cleaning and replacing it. Check the filters for
tears or small holes. A small hole can let dust pass
through and out of the filter. Do not use a filter with
holes or tears; replace it immediately.
STORAGE
Before storing your vacuum, the collection tank
should be emptied and cleaned. The accessories
should be cleaned and stored so they can be
readily available when needed. Store the wet/dry
vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be
performed only by qualified service personnel
using only identical replacement parts.
FIG. 30
FIG. 31
FIG. 32
FIG. 33
11 English