Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Manual (for qualified service personnel)
Before installation, please read these instructions
carefully.
For Your Safety
Warning
•
Be sure to disconnect the power cord while installing the
unit. Otherwise, it may cause electric shock or injury.
Caution
•
Be sure to put on a glove to avoid electric shock or
injury.
Installation Procedure
1
Remove the Lower Frame Cover and the Control-
Power Cover-Front from the elite Panaboard.
•
Unscrew the 2 screws (
Frame Cover from the elite Panaboard.
•
Unscrew the 4 screws (
Power Cover-Front from the elite Panaboard.
2
2
Unscrew the 6 screws (
Cover Plate.
3
1
) and remove the Lower
2
) and remove the Control-
1
3
) from the Control Board
3
As shown in the diagram below, open the Control
Board Cover Plate (
5
nector (
).
Remove the Control Board Cover Plate (
attach the Install-Free Kit (
6
4
Connect the connector (
5
Attach the Control Board Cover Plate (
3
the 6 screws (
).
6
Attach the Lower Frame Cover and the Control-
Power Cover-Front to the elite Panaboard.
•
Attach the Control-Power Cover-Front to the elite Pana-
board using the 4 screws (
•
Attach the Lower Frame Cover to the elite Panaboard
using the 2 screws (
4
), and disconnect the con-
4
6
).
5
4
5
) to the Control Board.
4
) using
2
).
1
).
) and
3
Publicité
Table des Matières
