Publicité
Les langues disponibles
Les langues disponibles
Step 4:
Installing the TV
1
Install the TV onto the TV Stand.
1 Referring to the outline of the supplied paper template,
match the outline of the Table-Top Stand to the paper
template outline, so that the holes at the bottom of the
Table-Top Stand align to the sleeves which were
attached in part 1 of the Step 3.
2 Slide the TV back to lock into place.
3 Remove the paper template from the Top Board.
Paper template
2
Attach the anchor bolts.
Secure the two supplied anchor bolts to the rear of the TV.
Anchor bolt
Note
If the two anchor bolts are not used to secure the TV, it may
fall and cause injury.
Step 5:
Safety measures to
prevent toppling over
WARNING
Be sure to take measures to prevent the TV Stand from
toppling over, and causing possible injury and damage.
1
Attach the support belt.
1 Screw the support belt (supplied with the TV) to the
TV Stand with the wood screw (supplied with the
TV) using the screwdriver.
2 Attach the support belt to the Table-Top Stand, and
screw the belt with the securing screw (supplied
with the TV) using a coin, etc.
3 Adjust the length by tightening the support belt
while holding the Table-Top Stand.
(Continued)
9
(US)
Publicité
