Sharp MD-MT90H Mode D'emploi page 126

Titling a MiniDisc (continued)
„ To add characters
1
Put the unit in the character input mode.
(Perform steps 1 - 2 on page 29.)
2
Press the VOL+ or VOL--- button to move the cur-
sor to the right of the character, where you want
to add a new character.
3
Select the character to add.
(Perform steps 3 - 4 on page 29.)
4
Press the ENTER/SYNC button.
5
Press the EDIT button.
6
"TOC" will be displayed. To write the updated
contents to the MiniDisc, press the /:OFF but-
ton.
You cannot remove the MiniDisc whilst "TOC" is
displayed. "TOC" will not disappear until the record-
ed contents have been updated.
E-31
ENGLISH
„ Stamping titles from another MiniDisc
Before stamping
When there are 2 MiniDiscs on which the same tracks
are recorded, you can transfer the character information
(disc and track names) of the Master MiniDisc to another
MiniDisc (for stamping).
1. What is a master MiniDisc?
A recordable MiniDisc that contains tracks and charac-
ter information. (You cannot transfer the information
from a playback only MiniDisc.)
2. What is a MiniDisc for stamping?
A MiniDisc that contains the same tracks in the same
order as the master MiniDisc. (Make sure that the total
number of tracks of the master MiniDisc and the one for
stamping are the same.)