Sharp MD-MT90H Mode D'emploi page 105

5
Press the PLAY/PAUSE button to start the MiniDisc
unit recording.
6
Begin playback on the stereo system, the output
will be recorded.
To interrupt recording
Press the PLAY/PAUSE button.
z To resume recording, press the PLAY/PAUSE button
again.
z The track number will be increased by one each time the
recording is interrupted.
To stop recording
Press the /:OFF button.
z When recording stops, "TOC" appears. Whilst "TOC"
appears the MiniDisc recorded contents have not yet
been updated.
z To prevent the new recording from being lost it is not pos-
sible to remove the MiniDisc whilst "TOC" is displayed.
To update the recorded contents of the Mini-
Disc
Press the /:OFF button whilst in the stop mode.
The power turns off after recorded contents have been
updated on the MiniDisc.
About the TOC
After any recording or editing function "TOC" (Table Of
Contents) is displayed. To finalise the recording or editing
function, press the /:OFF button. During this process
"TOC" will flash and "TOC EDIT!" will be displayed. Dur-
ing any recording or editing function the MiniDisc unit lid
is locked, the MiniDisc cannot be removed until the pro-
cess is finalised.
Warning:
If the power is removed (Battery/AC adaptor) whilst
"TOC" is displayed the MiniDisc unit lid will remain locked
until the battery/main power is restored and the unit is
turned on. Your new recordings or edited changes will be
lost and your MiniDisc may become unusable.
Caution:
Whilst "TOC" or "TOC EDIT!" is displayed, follow the
instructions below.
- Do not jerk or bump the unit.
- Do not unplug the AC adaptor.
- Do not remove the rechargeable battery or an alka-
line battery.
- Do not subject the unit to shock.
Otherwise, tracks may not be recorded properly.
Notes:
z Changing the volume level whilst recording does not
affect the recording.
z You cannot adjust the bass level whilst recording.
ENGLISH
E-10