Troubleshooting Guide - Faro LISBOA Instructions D'installation

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA
SICHERHEITSHINWEISE / VEILIGHEIDSINSTURCTIES INSTRUZIONI DI SICUREZZA
TROUBLE-SHOOTING GUIDE
PROBLEM
The fan does not start:
The fan is noisy:
The fan oscillates:
The light does not ignite
1. Check the fuses and circuit breakers.
2. Review the connections of the terminal block according to the
indications in the installation.
Ensure the power is off before doing this.
3. Make sure that the sliding switch is firmly in the position of up or
down. The ventilator does not work when the button is in the middle.
4. Make sure that the stabilizing tongue-pieces of the motor are off.
5. Finally if the fan will not start call an electrician do not attempt to
touch the internal parts.
1. Check that the screws in the motor casing are attached correctly.
2. Check that the screws fastening the blade brackets to the engine
block are properly tightened.
3. If using an optional light fitting, ensure the glass is properly fitted and
/ or the screws holding the glass are firm.
4. If a solid state speed control has been fitted this can cause noises in
the motor do not use these control.
5. Allow at least 24 hours for the fan to settle, as many noise will go
away. Each blade set is weighed and is a complete set, if installing
more than one fan do not mix the blades as this can cause wobble.
1. Check the blades are securely fastened to the holders.
2. Check the blade holders are tight on the motor
3. Ensure the mounting bracket is properly screws to the ceiling.
4. Interchange opposite blade sets if need be
In general , wobble is caused by the blade not cutting the air at the
same point measure down from the ceiling and make sure each
blade is at the same height to the ceiling, if they are not a small
adjustment can be made by hand by slightly bending the blade and
bracket. If a major adjustment is needed insert a washer (not
provided)
1. Check the terminal connections are tight.
2. Check for blown bulbs
3. If the light is still not working contact an electrician
SOLUTION
Faro
- 20 -