Reset Of All Settings; Reset Of A Single Setting - Geberit HyTronic Service-Handy Mode D'emploi

HyTronic Service Handy, Unidirectional
Operation

Reset of all settings

All settings are restored to factory settings.
Prerequisites
• Control is installed correctly and operating
• Contact with a control is established, see "Querying
and changing settings"
The command to reset cannot be reversed.
1
Go to menu item [FactrySet] [Werkeinst] and
press "OK". The number of the menu item can be
found in the operating instructions of the control.
22 ResetSens
23 FactrySet
24 CleanMode
30 MainProgr
2
The following information is displayed
22 ResetSens
23 FactrySet
24 CleanMode
3 Press button "R"
22 ResetSens
23 FactrySet
24 CleanMode
4
Confirm with "OK". Command to reset is
transmitted to control
Point to
Device!!
The following information is displayed when the
transmission is finished
GEBERIT
00 Bidirect
08 Unidirect
Settings
Result
Settings are now set to factory settings.
32
22 ResetSens
23 Werkeinst
24 Reinigung
30 Hauptmenü
22 ResetSens
23 Werkeinst
R?
24 Reinigung
22 ResetSens
23 Werkeinst
OK? OK?
24 Reinigung
Auf Sensor
richten!!
GEBERIT
00 Bidirekt
08 Unidirekt
Einstellung

Reset of a single setting

A single setting is restored to factory setting.
Prerequisites
• Control is installed correctly and operating
• Contact with a control is established, see "Querying
and changing settings"
Does not work with lavatory tap WT60.
The command to reset cannot be reversed.
1 Go to desired menu item and press "OK" (in the
example [IntervalT] [IntervalZ])
41
42 IntervalT
43 RunOnTime
2 Press button "R". Setting is set to factory setting.
The new value is indicated through an LED signal
in the sensor as a confirmation.
Result
R?
The setting is now restored to factory setting.
IntFlshT 41 IntervSpZ
42 IntervalZ
43 NachlaufZ