Safety Warnings; Installation Precautions - Fracarro OPT MBJ ottici Mode D'emploi

The product can only be installed by qualified personnel in compliance with local safety laws and regulations.
Fracarro Radioindustrie is exempt from all civil and criminal responsibility due to breaches of current legislation
derived from the improper use of the product by the installer, user or third parties.
The product must be used in full compliance with the instructions given in this manual in order to protect the
operator from all possible injury and the product from being damaged. Never remove the product cover as there
are live parts underneath it.

Installation precautions

● Damp and droplets from condensation could damage the product, consequently, install the product indoors.
● Damp and droplets from condensation could damage the product. Consequently, always wait for the product
to be perfectly dry before
● Handle with care. Any improper impact could damage the product.
● Leave plenty of space around the product to ensure sufficient ventilation. High temperatures or overheating
could compromise the operation and duration of the product.
● Do not install the product above or close to sources of heat, in dusty atmospheres or where it could be
exposed to corrosive substances. If the product is installed on the wall, use proper expansion bolts suitable
to the fixing support. The wall and the fixing support must be able to bear at least 4 times the equipment
weight.
Attention: to avoid being hurt, the unit must be mounted to the wall/floor according to the installation
For "PERMANENTLY INSTALLED" equipment, an easily accessible sectioning device must be integrated outside
the equipment; the "UNITS WITH PLUG" must be installed near a socket that is easy to reach. The unit must be
connected to the earth electrode of the antenna system, in compliance with the EN 60728-11
The earth screw is indicated with the symbol:
It is important to observe the provisions of the EN60728-11 standard and not to connect this screw to the earth
line power supply.
Never look inside the product's optical connectors. The laser radiation is not visible by the eye and so it is not
possible to prevent long term damage.
When you are working with the optical connectors of the divider, always make sure that the lasers of the optical
transmitters connected to it, if any, are turned off.
Class II symbol with functional earth connector
Earth symbol of the antenna installation
INVISIBLE LASER RADIATION
DO NOT VIEW DIRECTLY WHITH
OPTICAL INSTRUMENTS
(MAGNIFIERS)
CLASS 1M LASER PRODUCT
General warning
In the event of a failure, don't try to repair the product; otherwise, the warranty will no longer be valid. Only use the
supplied feeder. Despite the information given in this manual being carefully written, Fracarro Radioindustrie S.r.l.
keeps the right to change it at any time without prior notice and/or to improve and/or to change the products
described in this manual. See the website www.fracarro.com for more information about technical support and
warranties.

SAFETY WARNINGS

use.
LASER RADIATION
ATTENTION:
Invisible laser radiation.
Don't look directly.
Class 1M laser product
9
instructions.
standard.