Scope Of Use; Safety Information; Technical Data; Cleaning, Maintenance And Ordering Replacement Parts - EINHELL DLST 9+1 Mode D'emploi

Anleitung DLST 9+1 SPK 1
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Retain this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, hand over this
operating manual as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. SCOPE OF USE

The hose reel is suitable for use in enlarging the
radius within which your compressor can work.

2. SAFETY INFORMATION

After use, switch off the compressed air and
empty the hose, making it easier to roll the hose
up.
The equipment must only be operated in an
ambient temperature of +5°C to +40°C. The
hose must not be exposed to direct sunlight, as
otherwise this can result in damage to the hose.
Do not expose the equipment to rain. Never use
the equipment in damp or wet locations.
After use, the hose of the hose reel must be
disconnected from the compressor.
Protect the hose from heat, oil and sharp edges.
If the hose reel is not required, the hose should
always be rolled up!
3. Layout (Fig. 1)
1. Connecting hose
2. Hose
3. Hose reel
4. Angle mount
5. Suspension eye
6. Hose stopper
4. Assembly (Fig. 2)
The hose reel can be attached to a wall or ceiling
using either the suspension eye (5) or the angle
mount (4).
19.01.2005 13:43 Uhr Seite 7
5. Starting up
5.1 Connections
- Hose (1) to the connection on the compressor
- Hose (2) to the connection on the compressed air
tool
5.2 Rolling out
Pull out the hose (2) to the desired length from the
hose reel (3). The lock on the length of hose is
automatically activated if you let go of the hose (2)
and a grating sound is heard.
5.3 Rolling up
The lock can be released by a short pull on the hose
(2). Then feed the hose (2) evenly back into the
hose reel.
Important! The lock produces a grating sound when
the hose is being unrolled or rolled up.

6. TECHNICAL DATA

Max. permitted pressure:
Hose length:
Weight:
7. CLEANING, MAINTENANCE AND
ORDERING REPLACEMENT PARTS
7.1 Cleaning
Keep the housing and the hose as free of dust
and dirt as possible. Wipe the equipment with a
clean cloth or blow it with compressed air at low
pressure.
We recommend that the hose is cleaned before it
is fed back into the hose reel.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
GB
12 bar
9 +1m
3.0 kg
7