THOMSON MIC122DABBT Mode D'emploi page 24

Menu
1. Scan setting
Under FM mode, press [MENU] to enter the FM menu setting, then press
[Scan setting], then press [ENTER] for the sensitivity setting:
1.1. All stations:~ 15dB
1.2. Strong stations only: ~19dB,
2. Audio setting
2.1. Stereo allowed
2.2. Forced mono
2.3. System (FM system) same DAB system setting
3. PRESET:
3.1. Preset Recall (choose the station):
Press [ENTER] to tune to the station stored in the preset memory.
3.2. Preset Recall (choose the station):
You may store your preferred FM stations to the pre-set station memories. There are 20
memory presets in your radio. Presets are remembered by your radio in the event of a
power failure.
The procedure for setting presets and using them to tune stations is the same for DAB
modes:
Under the FM mode, select the desired wave band. Press
stations, press
then press [ENTER] for the desired pre-set number to which you wish to store the station.
Press [ENTER] to confirm.
or to tune to the required station as previously described, and
- EN 10 -
or to select
/ . to view the stored