THOMSON MIC122DABBT Mode D'emploi page 23

Preset
1. Preset recall
Under DAB mode, press
the station stored in the preset memory.
Note: If you have not previously stored a preset station and the preset button is pressed, "Empty
preset" will be displayed.
2. Preset Store
You may store your preferred DAB stations to the pre-set station memories. There are 20
memory presets in your radio. Presets are remembered by your radio in the event of a power
failure.
The procedure for setting presets and using them to tune stations is the same for DAB modes:
Under the DAB mode, select the desired wave band. Press
stations. Press
press [ENTER] for the desired pre-set number to which you wish to store the station. Press
[ENTER] to confirm.
FM Radio
Carefully extend the telescopic aerial fully
Auto scan
1. Press [SOURCE] to select "FM Mode''
2. Long Press
sufficient strength.
3. After a few seconds the display will update. The display will show the station frequency. If the
signal is strong enough and the station has RDS data present then the radio will display the
station name.
4. To find other stations, press and hold the
5. To scan the FM band in the opposite direction (high frequency to low frequency), press the
button and hold for 2 seconds.
6. When the waveband end is reached your radio will recommence tuning from the opposite
waveband end.
Manual scan
1. Press [SOURCE] on the main unit to select "FM Mode''.
2. Select FM mode as previously described if required.
3. Press or
50 kHz.
4. When the waveband end is reached the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure the aerial is extended and test the
reception by doing another auto scan in a different location.
or
or to tune to the required station as previously described, and then
key. Your radio will scan and stop automatically when it finds a station of
to tune to a station. With each press, the frequency will go up or down by
to select "Preset recall", then press [ENTER] to tune to
button as before.
- EN 9 -
/ . You can view the stored