IKEA FROSTIG Mode D'emploi page 12

ENGLISH
Problem
The appliance is noisy.
The appliance does not
operate. The Pilot light
does not flash.
The Pilot light flashes.
The Alarm light flashes.
The acoustic
sounds
The compressor oper-
ates continually.
The temperature in the
freezer is too low/high.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre. You can find the list at the
end of this manual.
Closing the door
1. Clean the door gaskets.
Possible cause
The appliance is not installed
properly.
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
The appliance has no power.
There is no voltage in the
mains socket.
The appliance is not working
properly.
The temperature in the freezer
is too high.
alarm The temperature in the freezer
is too high.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is too
high.
The Fast Freeze function is
switched on.
The temperature regulator is
not set correctly.
Solution
Check if the appliance stands
stable (all the feet should be on
the floor).
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Tempera-
ture Alarm"
Refer to "Excessive Tempera-
ture Alarm"
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open lon-
ger than necessary.
Let the product temperature
decrease to room temperature
before storage.
Decrease the room tempera-
ture.
Refer to "Fast Freeze function".
Set a higher/lower tempera-
ture.
2. If necessary, adjust the door. Refer to the
assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
12