DRAMINSKI EDc Mode D'emploi page 9

Upon switching on the device two flashing lines
will appear:
--
After pressing the switch for three times: digits 1, 2, 3
will be displayed, which indicate three consecutive
measurements have been recorded.
1
8
2
3
After pressing the switch again, the device
will display a result, which will be the effect of
a measurement cycle
1 0
level is sufficient, the device works properly and the
probe is not immersed in any solution.
(ie: the measurement are made in the air)
1 0
The lowest unit shown is 10, while the full range is
between 0 and 1990 units. When the highest value
is exceeded, the numbers
similar to when the measurement is taken in
the air. The measurement range of the device is
several times bigger than the maximum value of
vaginal mucus resistance. If the measurement is
taken correctly, it is not possible to exceed the
measurement range.
, showing that the battery
1 0 , will be displayed,