DrBrowns Natural Flow Deluxe Mode D'emploi page 4

Masquer les pouces Voir aussi pour Natural Flow Deluxe:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TO USE:
1. Before running this appliance, it is important that all bottles, bottle parts and/or
other accessories are clean. They must be washed, rinsed and empty.
2. Position the appliance on a flat surface and out of reach of children where it
cannot be knocked over or moved during operation.
3. Remove the measuring cup from the side storage compartment.
4. Fill the measuring cup to the fill line molded into the front of the measuring cup
with FRESH COLD WATER and pour the water INTO THE BOTTOM OF THE
HEATING CHAMBER.
NOTE:
DO NOT EXCEED the recommended amount of water. Please note that
hard water may increase build up or other residue on the heating plate. If you
have hard water, we recommend that you use filtered or distilled water.
5. Place the removable basket (part H) in the sterilizer heating chamber.
Arrange the bottles and other parts as shown in Figure A through Figure H.
NOTE:
Because of the difference in bottle and part size between standard and
wide neck bottle, different layouts are shown.
6. Insert the removable divider (part G).
7. Close the main cover (part B) and arrange the parts on the grate as shown in
Figure D and Figure H.
8. Close top cover (part A).
NOTE:
When plugging in the sterilizer for the first time, you will notice that the
power light will be on. THIS IS NOT AN ERROR. After the first cycle, the unit will
automatically shut off.
9. Plug the power cord into an electrical outlet. Press down on the start button
(part D). A light will come on behind the start button to indicate that the appliance
is running and creating steam. It will remain lit until the sterilization cycle is
complete. This is approximately 12 minutes but may vary by the amount of water
you add and other environmental factors. When the cycle is complete the light
will go out. Allow your appliance to cool for a minimum of 10 minutes between
cycles and prior to opening and handling the bottles and parts.
10. Open the main cover and remove all bottles and place on a countertop or other
flat surface. Open the top cover and re-assemble the bottles with the various
components.
4

Publicité

Table des Matières
loading

Produits Connexes pour DrBrowns Natural Flow Deluxe

Table des Matières