Service Data; Installation - Electrolux EZB2400AOX Notice D'utilisation

20 www.electrolux.com
Problem
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
Steam and condensation
settle on the food and in
the cavity of the oven.
The display shows "12.00". There was a power cut.

11.2 Service data

If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

12. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the
oven for too long.
plate is on the front frame of the
appliance cavity. Do not remove the
rating plate from the appliance cavity.
.........................................
.........................................
.........................................
Remedy
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Reset the clock.