Ego Power+ CH5500E Mode D'emploi page 9

TROUBLESHOOTING
PROBLEM CAUSE
Battery pack, adaptor or
Charger doesn't
charger is defective or
work. LED1 flashes
bad connection between
red or all the LEDs
the battery pack , adaptor
go out.
and charger.
Charger doesn't work Battery pack is too hot or
and LED1 shines red. too cold.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
SOLUTION
◾
Try to remove and reinsert the battery pack/ adaptor in the
charger.
◾
Try to remove and connect the adaptor to the battery pack
(For BAX1300).
◾
Try replacing an adaptor.
◾
Try charging a different battery pack.
◾
Unplug the charger and wait until the red LED goes out,
then reconnect the plug to the power supply.
Allow the battery pack to reach normal temperature. Charging
will begin when battery pack returns to 3°C-57°C (3°C-42°C
for BAX1300, 3°C -50°C for BA2240T).
56 VOLT RAPID CHARGER — CH5500E
EN
9