Work Men WMMT200-14TB Mode D'emploi page 25

Sawing
Use undamaged faultless saw blades only.
Deformed, blunt saw blades or saw blades that are
otherwise damaged can break.
When sawing light building materials,
observe the statutory provisions and the
recommendations of the material suppliers.
Plunge cuts may only be applied to soft
materials, such as wood, gypsum plaster
boards, etc.!
Before sawing with HCS saw blades in wood,
particle board, building materials, etc., check these
for foreign objects such as nails, screws, or similar.
If required, remove foreign objects or use BIM saw
blades.
Separating
Note: When separating wall tiles take into
consideration that the tools wear heavily when used
for longer periods of time.
Sanding
The removal rate and the sanding pattern are
primarily determined by the choice of sanding sheet,
the preset oscillation rate and the applied pressure.
Only flawless sanding sheets achieve good sanding
capacity and extend the service life of the machine.
Pay attention to apply uniform sanding pressure;
this increases the working life of the sanding sheets.
Intensifiying the sanding pressure does not lead to
an increase of the sanding capacity, but to
increased wear of the machine and the sanding
sheet.
For precise on-the-spot sanding of edges, corners
and hard to reach areas, it is also possible to work
only with the tip or an edge of the sanding plate.
A sanding sheet that has been used for metal
should not be used for other materials.
CLEANING AND MAINTENANCE
Attention! Before performing
any work on the equipment,
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
pull the power plug.
Lubrication
The machine requires no additional lubrication.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep the
machine and ventilation slots clean.
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-
sales service department.
_ If replacing the power cord is necessary, it
should be done by the manufacturer or his agent
to avoid a hazard.
AFTER-SALES SERVICE AND APPLICATION
SERVICE
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and
information on spare parts can also be found under:
www.eco-repa.com
WORK MEN application service team will gladly
answer questions concerning our products and their
accessories : sav@eco-repa.com
STORAGE
_ Thoroughly clean the whole machine and its
accessories.
_ Store it out of the reach of children, in a stable and
secure position, in a cool and dry place, avoid too
high and too low temperatures.
_ Protect it from exposure to direct sunlight. Keep it
in the dark, if possible.
_ Don't keep it in plastic bags to avoid humidity
build-up.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
GUARANTEE
Refer to the enclosed guarantee conditions for the
terms and conditions of guarantee.
ENVIRONMENT
Should your machine need
replacement after extended use,
do not put it in the domestic
waste but dispose of it in an
environmentally safe way.
Made in China 2015
25