Dust/Chip Extraction - Work Men WMMT200-14TB Mode D'emploi

Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding sheets are
available:
Matériau
– All wooden materials (e.g.,
hardwood, softwood, chipboard,
building board)
– Metal materials
– Paint
– Varnish
– Filling compound
– Filler
– Masonry, stone
– Marble
– Granite
– Glass
– Plexiglas
– Glass-fibre plastics

Dust/Chip Extraction

For sanding, always connect dust extraction.
Avoid touching or breathing-in dusts that are
harmful to one's health or carcinogenic. Always
use suitable dust extraction, work in well
ventilated areas and wear appropriate protective
equipment. When disposing of dusts, pay
attention that you or other persons do not
come into contact with these dusts. Dusts
dangerous to one's health develop, e.g., when
sanding lead-containing coatings, chemically treated
woods or some metals.
The vacuum cleaner must be suitable for the
material being worked.
When vacuuming dry dust that is especially
detrimental to health or carcinogenic, use a special
vacuum cleaner.
Operation
Starting Operation
Observe correct mains voltage! The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Power tools marked with 230 V can also be
operated with 220 V.
Utilisation
For coarse-sanding, e.g. of rough,
unplanned beams and boards
For face sanding and planing small
irregularities
For finish and fine sanding of wood
For sanding off paint
For sanding primer (e.g., for removing
brush dashes, drops of paint and paint
run)
For final sanding of primers before
coating
For shaping and braking edges
For final sanding and forming
For polish-sanding and rounding off
edges
Switching On and Off
To start the machine, push the On/Off switch 1
forward so that the "I" is indicated on the switch.
To switch off the machine, push the On/Off switch
1 toward the rear so that the "0" is indicated on the
switch.
Preselecting the Orbital Stroke Rate
With the thumbwheel for preselection of the orbital
stroke rate 2, you can preselect the required orbital
stroke rate, even during operation.
The required stroke rate depends on the material
and the working conditions and can be determined
through practical testing.
Operating Instructions
Note: Do not cover off the venting slots 3 of the
machine while working, as this reduces the working
life of the machine.
While working with HCS tools make sure that the
covering of the tools is undamaged.
Operating Principle
Due to the oscillating drive the application
tool/accessory swings up to 22000 times per minute
for 1.5° .
This allows for precise work in narrow spaces.
Grains
coarse
medium
fine
coarse
medium
fine
medium
fine
very fine
40
60
80
100
120
180
240
320
400
40
60
80
100
120
180
240
320
80
100
120
180
240
320
400
600
1200
24