Inno Essentials Silk'n Lipo H5001 Mode D'emploi page 21

Switch on. With the controls in view, press the control button on
6.
each treatment unit. The green and orange indicator lights will
go on. The orange indicator light will go off after a second or so
and the treatment unit will vibrate once. When the treatment
unit is in good contact with the skin, the green operating light
will blink slowly, and the laser energy will start to work.
Changing the EMS level:
7.
To increase: Short press the + button as many times as you
y
need to set to the EMS level that is comfortable for you. The
operating light blinks more quickly as you increase the EMS
level.
If you long press the + button, the EMS level will still only increase
a
by one increment.
To reduce: Short press the - button as many times as you
y
need (see section "4.2 Controls and settings").
Long pressing the - button, sets the EMS level back to zero.
a
Treat each area for 15 minutes. Keep the treatment unit in
8.
place, and the device on for up to 15 minutes. Every few minutes you
will feel a vibration. The vibrations are a normal part of the treatment
routine. At the end of 15 minutes, you will feel 3 vibrations, no more
energy will be emitted and the device will shut down automatically.
To switch off the device before 15 minutes, long press the
a
control button. You will feel 2 vibrations, then the device will
shut down.
9. If you want to treat another area (next to the area you have just
treated or another part of your body), wet the electrode pad, and
move the treatment unit to the next location.
a Try to avoid gaps and overlaps.
a If you move the device to another part of your body and the
treatment unit is not in good contact with the skin, the EMS
level will revert to zero. If this happens, make sure the treatment
pad is in good contact with the skin, then short press the control
button to start the device again, and then the + button to
increase the EMS level.
19
EN