Inno Essentials Silk'n Lipo H5001 Mode D'emploi page 17

4.4 Wetting the electrode pads
The electrode pads are required for the EMS to work, and they must be
wet before you start your treatment.
Wet each electrode pad with a wet cloth or with wet fingers.
1.
Then place the wet electrode pad onto the back of each
2.
treatment unit. Make sure that it fits firmly around the center
rectangle. You might need to manipulate it slightly, so that the
electrode pad lies flat on top of the treatment unit.
Electrode pad
It is important that you only wet the electrode pad, and not the whole
a
treatment unit.
4.5 Device charging
Charge each treatment unit before first use. The initial charge should
take around 6 hours. Subsequent charges should take around 3 hours. We
recommend you recharge the device before each treatment.
Remove the electrode pads before placing the treatment units
1.
in the stand/charging cradle.
Connect the empty stand/charging cradle to the electricity
2.
supply. The 2 charging indicator lights will be constant green.
15
Underside of the
treatment unit
EN