Tone Arm Height - Technics SL-1200G Mode D'emploi

Adjustment
Make this adjustment only if the cartridge you
are using makes it necessary.
Preparation
 Put a record on the turntable.
1
Release the arm lock.
Arm lock
2
Adjust the height with the arm-
height control ring.
Adjust the arm height until the tone arm
becomes parallel to the record.

Use the chart below as reference to find the
appropriate position mark for the height of
your cartridge.
(For supplied head shell)
Cartridge height
(H) in millimeters

Turn the arm-height
control ring to align
the position mark
with the index line.
0 to 6 mm are
marked on the arm
height control ring.
18
(18)
English
(continued)

Tone arm height

(Released)
(Locked)
Height control
position
17 0
18 1
19 2
20 3
21 4
22 5
23 6
Index line
Arm-height control
ring
3
After arm height adjustment is
finished, lock the tone arm by
turning the arm lock knob.
 
When you don't know the cartridge
height (H),
Remove the stylus cover, taking care not to
damage the stylus, then release the arm clamp.
Lower the cue lever, rest the stylus on the
record and adjust the height control until the
tone arm and record are parallel.
Parallel to the turntable
Attention
 Be careful not to damage the stylus tip.
 Do not use the product with the arm lock
released.