Using The Manual Pump - Beurer BY 70 Mode D'emploi

5. To switch on the breast pump, press the
pump must be connected to the silicone tube for one-sided
pumping and to 1 small bottle. The breast pump will begin au-
tomatically in stimulation mode (
will appear on the display. During these two minutes, your breast
nipple will be stimulated in order to prepare it for pumping the
breast milk. Use the
lation intensity.
6. After the two minutes have passed,
the display. To begin pumping the breast milk, press the
button. Use the
that is comfortable for you. Stop using the pump once there is
180 ml of milk in the bottle.
7. If you want to switch back to stimulation mode, press the
button. The stimulation and the two-minute timer will start
from the beginning.
The breast pump has a memory function, which recalls
the last programmed stimulation or pumping level when
it is switched on.
8. To switch off the breast pump, press the

7.4 Using the manual pump

1. Remove the cap with the connection to the breast pump and at-
tach the manual pump device including the silicone membrane by
pressing the silicone membrane firmly onto the pump attachment
until it clicks into place.
2. Then place the breast shield with silicone cushion gently on the
breast. Make sure that the nipple is completely enclosed and there
are no air pockets. To ensure proper function, the breast shield
must be drawn firmly onto the breast. Use the manual pump as
shown in the image.
3. You can vary the pump intensity by selecting between the MIN/
MAX markings that can be seen.
) and a two-minute timer
/ buttons to set the desired stimu-
/ buttons to select a suction intensity
button. The breast
will start to flash on
button.
29
1. Switch on
stimulation
mode
2. Intensity
3. Start pumping
4. Intensity
5. Back to stimulation mode