Safety Information - LD Systems DEFENDER Série Manuel D'utilisation

SERIES

SAFETY INFORMATION

All cable crossovers in the DEFENDER series are designed to protect cables of all types against damage, and visi-
tors as well as operators from injuries by tripping. To ensure these goals, the following safety instructions for use
of the cable protectors must be observed:
• This user's manual is an integral part of the product and must be read carefully before use.
• DEFENDER cable crossovers may only be used in accordance with their intended purposes and maximum load-
bearing capacity. Valid parameters can be found in the detailed description of the respective product variant.
• DEFENDER cable crossovers are designed for use on firm and level ground. The load specified in the detailed
descriptions is achieved only on level and solid ground. Load-bearing capacity may be greatly reduced on
uneven or soft ground.
Please note that additional markings / hazard warnings or even permits may be required when using cable
crossovers on public thoroughfares, walkways, etc.
• Use DEFENDER cable crossovers only with original replacement parts and accessories.
ESPECIALLY IMPORTANT:
• Do not modify the product in ANY way. Modifications to the DEFENDER cable protector
change the product's characteristics, reduce its protective effect, and lead to a loss of the warranty.
• Do NOT bridge over ANY ditches, shafts, stairs, or similar depressions.
• Do NOT support pedestals, scaffolding, beams, and similar on the cable protectors.
• Do NOT run rigid gas lines in the cable protectors.
• Do NOT run cables with a voltage >500V in the cable protectors.
• Fill the cable ducts up to a max. of 70% to the underside of the cover.
To ensure that the trip protection does not itself become a tripping hazard:
• Connect the cable protectors in complete sections.
• Check that the connectors are flush for each installation.
• Check that the lid closures function for each installation.
• Make sure that the lid closure snaps securely into the base.
• Keep the hinge area and lid closure clean.
• Remove any excess lubricant from the hinges after care.
3