Connection Diagram - Pioneer PRS-D3000SPL Mode D'emploi

Connection Diagram

Grommet
Grommet
The maximum length
of the wire between the
fuse and the positive
(+) terminal of the bat-
tery is 45 cm.
Grommet
Fuse (100 A)
Each amplifier must be SEPARATELY
fused at 100 A.
Optional direct ground
wire (sold separately)
When chassis ground-
ing is not sufficient,
direct grounding
should be used. The
wire size should be
same size as the bat-
tery wire.
System remote control wire (sold separately)
Connect the male terminal of this wire to the system remote control terminal
of the car stereo (SYSTEM REMOTE CONTROL). The female terminal
can be connected to the auto-antenna relay control terminal. If the car stereo
does not have a system remote control terminal, connect the male terminal to
the power terminal through the ignition switch.
Positive (+)
terminal
Battery
SYNC OUTPUT /
SYNC INPUT jack
See the "Connecting the
Speaker Wires" section
for SYNC OUTPUT /
SYNC INPUT jack con-
nection instructions.
Reverse side
Ground wire (sold separately)
The ground wires must be same size
as the battery wire.
Connect to metal body or chassis.
Battery wire (sold separately)
For the wire size, see the
"Connecting the Power Terminal"
section. The battery wire, the
ground wire and the optional direct
Negative (–)
ground wire must be same size.
terminal
After making all other connections
at the amplifier, connect the bat-
tery wire terminal of the amplifier
to the positive (+) terminal of the
battery.
Connecting wire with RCA
pin plugs (sold separately).
External Output
(Subwoofer output)
RCA input jack
Speaker terminal
See the "Connecting the
Speaker Wires" section for
speaker connection instruc-
tions.
Car stereo with
RCA output
jacks
6