Konyks eCosy Manuel D'utilisation page 14

To operate, eCosy needs to use the pilot wire. Pilot wire
mode must be activated on the thermostat of the elec-
tric heater. The pilot wire mode is often represented
by the design of a clock, a house, the word «PROG» or
the word «AUTO» (refer to your heater's user manual).
Increase the temperature on your thermostat to the
maximum, your heater will start to heat.
Press the control button on the eCosy. With each press,
your heater will change its heating rate. Set it on OFF
and check that the heater no longer heats.
Switch off the main power again then fix your radiator
and your eCosy module in the appropriate locations.
KONYKS APP INSTALLATION
If you have an Android phone go to Google Play.
If you have an iPhone phone go to APP Store.
Install the Konyks application, open it then Click on
«Create a new account».
Enter your email address as a username then choose
your password.
14