Konyks eCosy Manuel D'utilisation page 13

Connect the cables (wire)
Connect the Neutral wire (Blue) of the eCosy to the
neutral wire of the heater (blue or gray)
Connect the Live wire (Brown) of the eCosy to the Live
wire of the electric heater (red or brown)
After installing eCosy:
Wall side
INSTALLATION DU eCOSY
Please note that the presence of a connector is not sys-
tematic, another way of connection can be used. In this
case, the logic remains the same, care must be taken
that the Live, Neutral and Pilot wire from eCosy are in-
serted in the same locations as those of the electric
heater to create the connection.
Check the connection with the electric heater
Before pairing the eCosy module with the Konyks APP,
check that the box communicates well with the heater :
Turn on the power.
Activate the pilot wire mode on the thermostat of the
electric heater.
eCosy wires
Electric heater
wires
13