Function - Franke AQUAPAY AQUA800 Notice De Montage Et De Mise En Service

11.9 Pull off the Piezo pushbutton from sensor connector 1 (G) of the electronic module.
A: Solenoid valve cartridge mixed water (Actuator 1)
B: Solenoid valve cartridge, bypass (Actuator 2)
C:Analogue output 0-10 V
D:Temperature sensor, cold water
E: Temperature sensor, hot water
F: Sensor connector 2/3
G:Sensor connector 1
H:Electric T-junction system cable (power)
K: Electronic module
11.10 Connect the Y-sensor junction to the sensor connector 1 (G).
11.11 Connect the Piezo pushbutton and the display of the coin-activated switch to the Y-
sensor junction.
11.12 Connect the coin slot to the sensor connector 2/3.
11.13 Connect the shower.
11.14 Insert the coin receptacle.
11.15 Close the door of the coin-activated switch.
11.16 The coin-activated switch is ready for operation.

12. Function

12.1 The display (a) reads "Pay".
12.2 Insert the coins in the coin tester (b).
• The flow duration is displayed.
12.3 10 s after the last coin has been inserted, the shower is enabled.
• The residual time is displayed.
- 7 -