English - Koenig KWK240 Mode D'emploi

English

Congratulations
Thanks for your purchase of a KOENIC product.
Please read this manual carefully and keep it for
future reference.
Before first time use
1. Unwrapp the BRITA MAXTRA filter cartidge.
Immerse the cartridge in cold water and shake
gently to remove any air bubbles.
2. Insert the cartridge into the filter funnel and
push it firmly into place. When correctly fitted,
the cartridge should remain in place when the
funnel is turned upside-down.
3. Fill the filter funnel with water and allow it to
filter through, then discard the water. Repeat
this process.
4. To replace the cartridge after four weeks,
simply pull the tab which is mounted on top
of the cartridge. To insert the new cartridge,
please observe steps 1-3.
How the BRITA MEMO works
A bar disappears after every week. The remain-
ing bars in the display indicate the remaining
cartridge life. Replace the cartridge when all of
the bars have disappeared (after approximately
four weeks) and the arrow starts to flash. Install
a new filter cartridge in accordance with the
instructions and reactivate the cartridge change
indicator as described above.
Note
• The Memo is only intended to be used with
BRITA MAXTRA filter cartridges.
18
1
Immerse the cartridge
in cold water and
shake it.
3
Fill the filter funnel
with water.
Caution
•
Never use the kettle without the filter
funnel or BRITA MAXTRA filter cartridge
in place.
•
When filling or carrying the kettle, care
should be taken to ensure it is not tilted
backwards as this may allow water to pass
on the control area, trough the steam
aperture. Should this occur, let the kettle
dry completely before use.
2
Insert the cartridge
into the filter
funnel and push it
firmly into place.
4
Press START to set
electronic cartridge
exchange indicator.