Publicité
Loosen the screws
and turn down the cover
Make sure there are no other installations close to the drill holes (e. g. electric wirings, water pipes) – Fix
the console
with the screws
tions according to figures 5-7. Knock out the prepunched hole at the provided cable bushing and press in
the cable bushing sockets
appliance that way so the heat is radiated into the desired direction.
Operation of the appliance
Turn on/off the appliance by means of the circuit breaker. If you use the appliance with a series switch,
you can select between the heating levels full and medium.
Cleaning the device
- Disconnect the appliance via the all-polo disconnecting switch (fuse) and let it cool down.
- When needed, wipe the device with a slightly damp cloth.
- To remove dust from the reflector and heating elements you can use a brush with long soft bristles.
- When the device is heavily contaminated, get it cleaned by an expert.
Possible faults and causes
Fault
Cause
The heating
The device is turned off.
elements do
The relevant household fuse has blown or
not radiate
the circuit breaker has been activated.
any heat.
If you have tried all the above and the appliance still does not work, please refer to your dealer or a service
centre.
Maintenance
The device is maintenance-free.
Disposal
For the safe and environmentally-friendly disposal of the appliance, please contact your dealer or the man-
ufacturer.
- Drill two holes with Ø 6mm into the wall (see figure 4).
and the dowels
at the wall. Let a specialist make the electric connec-
– Turn up the cover and fix its position with the two screws
Remedy
Turn on the appliance.
Check the fuse / circuit breaker and make
sure that no other high power devices share
the same fuse / circuit breaker.
- Place the
5
Publicité
