Controls And Indicators - Candy GCC 570NB Manuel D'instructions

Control Panel and Indicator Lights
Programme Selector – Select the required
programme
Delay Start button
delay the start of the drying cycle (see details
of Operation on page 10)
Start/Pause button
commence the selected drying programme
Delicates button
the heat level for delicate items, the indicator
above the button will light up. To change the
heat setting the programme must be reset
Low Heat – Indicator light ON
High Heat – Indicator light OFF
Filter Care indicator
filter needs cleaning
Empty Water indicator
water container is full
Progress display
DRY – When the programme is selected the
DRY indicator will flash, when the programme
starts the DRY indicator will light up.
– Indicator lights when there is a short time
left until completion of the programme. At this
stage of the drying cycle the machine enters the
Cool Down phase.
The length of the Cool Down phase varies
between 10 and 15 minutes depending on the
programme.
END – Indicator lights when the programme is
finished.

CONTROLS AND INDICATORS

Water Tank Filter Care
Indicator Indicator
Start/Pause
Button
– Allows the user to
– Press to
– Press to reduce
– lights when the
– lights when the
Progress
Display
Delay Start
Button
SELECTING THE PROGRAMME
The Sensor Dry machine gives many options
for drying the laundry to suit all circumstances.
The table on the next page lists the
programmes and the function of each
programme.
Note: The sensor may not detect a small load of
small articles. For small loads and separate
items or pre-dried fabrics with low moisture
content, use the timed programmes.
Set the programme between 30 and 75 minutes
depending on the load size and dryness
required, and select high or low heat depending
upon the fabric type.
If the sensor does not detect the item the dryer
will only operate for 10 minutes before going
into cooldown.
If the load is too large or too wet to tumble dry
the dryer will automatically go into cooldown
after approximately 3 hours.
Delicates
Button
Programme
Selector
EN 9