Operation Instructions - erba 03189 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Before using the hydraulic jack you have to vent any excess air that may be trapped in the hydraluc
system (perform this every time you use this product):
Put the handle (1) in the socket (4) and tighten it with the screw that is on the back of the socket.
Turn the handle counterclockwise and execute a few pumping motions (moving the handle up
and down). This action should lubricate and ventilate the hydraulic jack.
Make sure the wheels of the hydraulic jack are not jammed. They should be able to move freely.
To lift the hydralic arm of the jack turn the handle clockwise and execute pumping motions.
Use all the available range of the handle for a quick and effective lifting motion (B).
Always use support stands to secure the vehicle (C).
After you finished the repairs on the vehicle, lift the vehicle slightly so that you can remove the
support stands.
Make sure there are no persons under the vehicle before you lower it
Turn the handle counterclockwise to lower the hydraulic arm of the jack.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 13
Changes, print, punctuation and other errors reserved!
Instruction manual
03189
Issue: 06/2018