GB - INSTRUCTION MANUAL
7. IMPORTANT INFORMATION FOR INITIAL OPERATION
The product needs assembly (A).
8. OPERATION INSTRUCTIONS
Pressing
Put the pressure plates (5) on the working table. Put the workpiece on the plate.
Close the release valve (clockwise).
Start pumping untill the piston has reached the workpiece.
Adjust the workpiece dead center below the piston.
Continue to pump to start pressing the workpiece.
Stop pumping once you have acheived the desired pressing result.
Slowly open the release valve (counterclockwise) to retract the piston.
Once the piston has retracted completely, remove the workpiece.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 13
Changes, print, punctuation and other errors reserved!
Instruction manual
03168
Issue: 11/2017