GB - INSTRUCTION MANUAL
9. SERVICE AND REPLACEMENT PARTS
Servicing and repairing the hydraulic shop press must only be done by authorized professionals.
Keep the hydraulic shop press clean and its moving parts well lubricated.
Use only original spare parts.
Inspect the hydraulic shop press before each use. If you notice any damage or leakage, do not use it!
If you have reason to believe that the hydraulic shop press has been overloaded or subjected to
heavy impacts, do not use it untill the necessary steps to fix the product have been undertaken.
Do not modify the hydraulic shop press!
Check the hydraulic jack for rust on a regular basis. Clean the product with a clean cloth and a little
bit of oil.
10. WARRANTY
Legal warranty regulations apply.
11. DISPOSAL
Our products are packed in order to prevent damage during transport. Packing materials are va-
luable resurces and therefore can and should be recycled. The product itself consists of various
materials (metals, oils, plastic, etc.) and should be disposed with care and in accordance with your
federal and local disposal regulations.
12. LEGAL INFORMATION
All rights reserved. This manual is copyrighted. Reproduction in and form (digital, print, etc.) is
strictly prohibited without the written permission of ERBA GmbH.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 14
Changes, print, punctuation and other errors reserved!
Instruction manual
03168
Issue: 11/2017